Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions26,920
- Orphaned Marques
- ↳ Hudson20,986
- ↳ Street Rods798
- ↳ Off Topic556
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker121
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,394
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- ralpie August 2010
- walts garage-53 August 2010
wa-1 carburator
-
Can the metering rods of a wa-1 carb be changed, that is be re-manufactured to match for a twin-h setup? Or does the rebuild kits have new metering rods? I would like to know because I do not want to have a mismatched set and cause problems on a twin-h
-
The metering rods for all WA-1 carburetors are replaceable. The metering rods are not part of a rebuild kit. In the past the metering rods were available for purchase. Today new metering rods are like most all other old car parts...something you have to find via the swapmeet, old parts vendors etc.
There are several companies who specialize in the rebuild of carburetors, but I am unsure if they offer NOS replacement metering rods. -
eddynghdsn16 wrote:
If it,s a 968s or 2113s, those are for a Hornet 308 engine, I can rebuild them for you with the correct metering rods. WaltCan the metering rods of a wa-1 carb be changed, that is be re-manufactured to match for a twin-h setup? Or does the rebuild kits have new metering rods? I would like to know because I do not want to have a mismatched set and cause problems on a twin-h
