Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,068
- Orphaned Marques
- ↳ Hudson21,136
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- dave kastelic July 2010
- hudsontech July 2010
38 112 Pictures
-
More pictures
Hudson heater 007_128004623452744.jpg639 x 479 - 25K
hudson pictures #10 007_128007252652744.jpg639 x 479 - 51K
hudson pictures #13 003_128011002852744.jpg1516 x 1137 - 87K
hudson pictures #13 014_128011774852744.jpg963 x 722 - 95K
hudson pictures #13 019_128010132952744.jpg1023 x 767 - 79K -
I posted quite a few more pictures on two other threads on this page.
-
Looking good Dave - that engine is beautiful. Looks almost to nice to put into the car - more like on a display stand in the living room!!!!! Oh sure, that'll work. My wife (at the time) wasn't really thrilled with me rebuilding a carby on the kitchen table - but, hey, it was winter in Maine where we lived and about 30 degrees below zero in barn. Wives don't understand those things.
Hey, when I went out to visit Kelly Hinegardner over in Arkansas before he passed away he had a Moto Guzzi motorcycle on display in his living room in front of the fireplace. His wife was comfortable with it.
Hudsonly,
Alex Burr
Memphis, TN -
Thank you Alex. I got a fuel pump in the mail from Dale Cooper this past Friday. It really looks nice and I will get it bolted on tomarrow. That and getting all the raised areas painted black should really make it look good. It only cost me about $50 bucks and a few hours of my time to get it done once it was cleaned up.
-
I missed posting this picture of the motor earlier.
hudson pictures #13 020_128031414252744.jpg1023 x 767 - 79K
