Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

In this Discussion

rear door and side panel newly upholested
  • bartibog1bartibog1
    Posts: 222Expert Adviser
    got the one rear door panel and panel beside rear set back from

    upholester today looking great. will be better on door

    steve
    hudson material 001_127986197947349.jpg
    639 x 479 - 40K
  • RL ChiltonRL Chilton
    Posts: 3,458Platinum Member
    Woo-Hoo! Those look beautiful.;)
  • Lee ODellLee ODell
    Posts: 1,838Platinum Member
    Looks very good. Lee
  • Hudson308Hudson308
    Posts: 1,405Platinum Member
    Those are purdy. They look original, too.
    Workin Stiff
  • dougsondougson
    Posts: 599Platinum Member
    Just curious. What will it cost you for the complete set?
  • bartibog1bartibog1
    Posts: 222Expert Adviser
    the whole interior will likely 5 to 6000 but will be a beautiful thing

    when finished. the panels were made from scratch only piece reused was under arm rest

    steve
  • bartibog1bartibog1
    Posts: 222Expert Adviser
    door panel is now fitted to door. looks great to me.

    doing seats now

    steve
    hudson material 006_128106125147349.jpg
    639 x 479 - 41K
  • duncan
    Posts: 403Gold Member
    were you able to use the original pieces of tin that hold the botton of the door panels to the doors or did you make new ones I need some for our 54 Hornet Hollywood Thanks Ray:D
  • bartibog1bartibog1
    Posts: 222Expert Adviser
    i blasted both old pieces and and reused

    you could likely have new ones made by a tinsmith

    and spot weld them to door and squezze them on

    new panels

    ssteve
  • bartibog1bartibog1
    Posts: 222Expert Adviser
    front seat came back from upholester today
    hudson material 001_128217371847349.jpg
    640 x 480 - 96K
    hudson material 002_128217147547349.jpg
    640 x 480 - 94K