Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,040
- Orphaned Marques
- ↳ Hudson21,111
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- dougson December 2009
- RL Chilton December 2009
- Roger Harmon December 2009
- walts garage-53 December 2009
- WildWasp December 2009
Is this a Clifford short header?
-
R/ Roger.
-
No, it is not
-
Roger Harmon wrote:
Need a picture of the bolt on flange before I can say. Walt. -
WildWasp-
Does that mean it will fit a Hornet? -
I compared it to a picture I found of a clifford header. the flange at the block looks the same. The tubes on this one seem to hug the block more. That's fine with me, as long as it'll fit on a SWB car. What do you guys think?
R/ Roger.R/ Roger. -
I would ask for clearer pictures, it appears to have a single outlet but the header on the Clifford website has dual outlets and is "short". The ebay header looks "long" to me.
