Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,029
- Orphaned Marques
- ↳ Hudson21,101
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,958
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- 37 Terraplane#2 October 2009
- tanlikesand October 2009
- wizade October 2009
Steel fuel line , 54 customline I-6
-
What are my options for replacing the steel fuel line that is between the fuel pump and the carburetor on my 1954 Ford Customline (Inline 6) ?
While replacing the Carb, I bent/snapped off the end section of the tube!! The problem I have now is that I can't seem to find this part anywhere?
I've searched the parts on the big classic ford sites, and I can't find it anywhere.
Thoughts? -
cant u go to the parts store and get a steel line and get it bent? most part stores will bend it for u if u take the old one with u....
-
use steel brake line of the same size, 2 or more can be joined to get enough length , you can buy a hand held bender for a few bucks , it will come in handy again later on . BUD
-
Thanks guys!! good idea....
