Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,043
- Orphaned Marques
- ↳ Hudson21,114
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors148
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
Checking dwell on 6 volt systems
-
I have an Actron Tach Dwell meter and I was not sure if I got an accurate reading on my RPM's and dwell varification on the 54 which is a 6 volt system. Is there any equipment out there available.
I set my points at .026 and plugs at .030 per my 56 manual. I will recheck these settings when I get my 52-54 shop manual.
Any advice is appreaciated
Jim -
Private message me if you would like "my opinion".
Phil. -
Will do Phil, I 'm here to learn.
JMC
