Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,055
- Orphaned Marques
- ↳ Hudson21,125
- ↳ Street Rods807
- ↳ Off Topic573
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,959
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- walts garage-53 October 2009
Distributor 1Gt-4204A-1
-
Does anyone out there know the difference between the 1GT-4204A-1 and the 1GT- 4204B-1 distributor that was used on the Hudson 8 as I see it listed in the Master Parts Catalogue as both fitting the same engine and wonder if either will work?
-
41truck wrote:
The IGT-4204A-1, centrifugal is 17.5 degrees advance at 1700 RPM's, vacuum is 8.5 at 14 inches of mercury, for a total of 26 degrees advance, fits 1948 and 1949 Hudson eights. The IGT-4204B-1 fits 1950 to 1952 Hudson eights. The only difference is the vacuum advance is only 3.5 at 16 inches of mercury, for a total of 21 degrees. You can use either in 48-52 eights. This is all in my tech tip books I sell. Walt.Does anyone out there know the difference between the 1GT-4204A-1 and the 1GT- 4204B-1 distributor that was used on the Hudson 8 as I see it listed in the Master Parts Catalogue as both fitting the same engine and wonder if either will work?
