Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,058
- Orphaned Marques
- ↳ Hudson21,124
- ↳ Street Rods801
- ↳ Off Topic559
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash71
- ↳ Packard163
- ↳ Studebaker121
- Classic American Cars
- ↳ Ford Motor Company959
- ↳ Chrysler Corporation478
- ↳ GM Corporation1,394
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,961
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- 37 Terraplane#2 September 2009
- terraplane8 September 2009
gas tank filler pipe grommet
-
Can this be replaced on a '36 Hudson without having to remove the tank and pipe?
-
terraplane8 wrote:Can this be replaced on a '36 Hudson without having to remove the tank and pipe?
If your talking about the one on the outside at the body , yes , the old one will be hard so you may have to cut it but the new one will go on OK--BUD -
Bud, yes that's the one I meant thanks. I'm installing my new F**d fuel gauge sender unit and want to put the tank back in so I can drive the car while I'm waiting for the new grommet to arrive (actually I haven't even ordered it yet from K-Gap). The old grommet basically broke into pieces and is totally useless now.
