Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,073
- Orphaned Marques
- ↳ Hudson21,138
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,962
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- walts garage-53 August 2009
Sterring Box Gaskets
-
Does anyone out there sell the two gaskets for the stepdown steering box? I've checked different sites K-Gap etc. with no luck
Glenn -
53hudsonguy wrote:
The cover gasket you will have to make. The gaskets that go on the bottom plate are special. They are about 2 or 3 thousand thick and this is how you adjust the clearance for the bearings on the worm gear. Hudson put about 10 of these gaskets there for adjustments. I believe I have some of these gaskets so if you want, e-mail me at waltmordenti@aol.com. Walt.Does anyone out there sell the two gaskets for the stepdown steering box? I've checked different sites K-Gap etc. with no luck
Glenn
