Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!
Categories
- All Discussions27,065
- Orphaned Marques
- ↳ Hudson21,134
- ↳ Street Rods807
- ↳ Off Topic574
- ↳ American Motors149
- ↳ Kaiser - Frazer70
- ↳ Nash70
- ↳ Packard163
- ↳ Studebaker122
- Classic American Cars
- ↳ Ford Motor Company956
- ↳ Chrysler Corporation477
- ↳ GM Corporation1,396
- ↳ Post War Chevrolets75
- ↳ Pontiac Forum119
- General
- ↳ All makes1,960
- ↳ Poll Discussions24
- Swapmeets & Events
- ↳ Events130
- ↳ Swapmeets108
- Hot Rod Corner
- ↳ Ford Rods90
- ↳ Lead Sleds67
- Special Interest Groups
- ↳ The Flathead Forum139
- European marques
- ↳ MG Car Company2
- ↳ Mercedes-Benz2
In this Discussion
- hudsonkid July 2009
- jjbubaboy July 2009
- rambos_ride July 2009
Wanted: Also need a metering rod for my carb.
-
jjbubaboy wrote:Hey all,
Where would I look to find a # 75-411 metering rod for my Carter WA 1 carb?
Any leads or ideas would be great!
Thanks again!
T Jeff
I've got 4, and only need 2 of them for my build...they all start with "75-" have different end sequence numbers...anyone know if these are all interchangable or are they specific based on the end sequences? -
Hey Dan,
From what I have come up with they are different based on the carb model.
Different models take different sequences and some are even different lengths.
My spec sheet lists 4 specific rods as: standard, 1 step lean, 2 steps lean, and 3 steps lean.
T Jeff -
jjbubaboy wrote:Hey Dan,
are any of them 75-411?
If anyone by chance comes across one at the Nat'l (and it isnt a $mall fortune!) and could pick it up for me that would be most wonderful!
I would then purchase it from you
THANKS,
T Jeff
Not one of them!
In fact there are no matching numbers out of all 4 if I recall - I'm going out to the shop later I'll get the exact numbers and post them.
